Re: Async Escape Map
Отправлено: Игорь Масленников on October 22, 1999 at 11:12:57:
В ответ на: Async Escape Map posted by Oleg Shpak on October 20, 1999 at 18:44:35:
А conf t - line 104 - escape-character ... не пробовали? Игорь > Привет, All! > Кто подскажет, как изменить Async Escape Map
> с того что выдается по умолчанию ( 0xa0000 ) на 0x0 ?
> c3640+MICA modems > din9#sh line 104
> Tty Typ Tx/Rx A Modem Roty AccO AccI Uses Noise Overruns Int
> A 104 TTY - DialIn - - - 343 0 0/0 - > Line 104, Location: "PPP: 195.248.164.132", Type: ""
> Length: 24 lines, Width: 80 columns
> Status: Ready, Active, No Exit Banner, Async Interface Active
> HW PPP Support Active, Modem Detected
> Capabilities: EXEC Suppressed, Hardware Flowcontrol In,
> Hardware Flowcontrol Out, Modem RI is CD, Line usable as async interface
> Modem Autoconfigure, Integrated Modem
> Modem state: Ready
> modem(slot/port):3/7, csm_state:CONNECTED_STATE,
> bchan_num:17 csm_status: CALL_ACTIVE > Line is running PPP for address 195.248.164.132.
> 0 output packets queued, 0 input packets.
> Async Escape map is 00000000000000000101000000000000
> Вот это ^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^ ? > Modem hardware state: CTS DSR DTR RTS > Спасибо,
> Олег.
Отклики:
Написать ответ
|
