Async Escape Map
Отправлено: Oleg Shpak on October 20, 1999 at 18:44:35:
Привет, All! Кто подскажет, как изменить Async Escape Map
с того что выдается по умолчанию ( 0xa0000 ) на 0x0 ?
c3640+MICA modems din9#sh line 104
Tty Typ Tx/Rx A Modem Roty AccO AccI Uses Noise Overruns Int
A 104 TTY - DialIn - - - 343 0 0/0 - Line 104, Location: "PPP: 195.248.164.132", Type: ""
Length: 24 lines, Width: 80 columns
Status: Ready, Active, No Exit Banner, Async Interface Active
HW PPP Support Active, Modem Detected
Capabilities: EXEC Suppressed, Hardware Flowcontrol In,
Hardware Flowcontrol Out, Modem RI is CD, Line usable as async interface
Modem Autoconfigure, Integrated Modem
Modem state: Ready
modem(slot/port):3/7, csm_state:CONNECTED_STATE,
bchan_num:17 csm_status: CALL_ACTIVE Line is running PPP for address 195.248.164.132.
0 output packets queued, 0 input packets.
Async Escape map is 00000000000000000101000000000000
Вот это ^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^ ? Modem hardware state: CTS DSR DTR RTS Спасибо,
Олег.
Отклики:
Написать ответ
|
