Re: Не взводится DTR ......

Отправлено: Yuri A. Kuznecov on September 30, 1999 at 16:52:35:

В ответ на: Re: Не взводится DTR ...... posted by FiSh on September 30, 1999 at 16:10:40:

> Если по sh line X-
> ...Modem hardware state: noCTS noDSR DTR RTS...
> проблемы у кабеля или модема.

cisco4700#sh line 2
Tty Typ Tx/Rx A Modem Roty AccO AccI Uses Noise Overruns Int
A 2 TTY 38400/38400 - - - - - 1 0 0/0 Se2

Line 2, Location: "", Type: ""
Length: 24 lines, Width: 80 columns
Baud rate (TX/RX) is 38400/38400, no parity, 2 stopbits, 8 databits
Status: Ready, Active, Async Interface Active
Capabilities: Hardware Flowcontrol In, Hardware Flowcontrol Out
Line is permanent async interface
Modem state: Ready
Line is running SLIP.
13 output packets queued, 0 input packets.

Modem hardware state: CTS DSR noDTR RTS
Special Chars: Escape Hold Stop Start Disconnect Activation
^^x none - - none
Timeouts: Idle EXEC Idle Session Modem Answer Session Dispatch
00:10:00 never none not set
Idle Session Disconnect Warning
never
Login-sequence User Response
00:00:30
Autoselect Initial Wait
not set
Modem type is unknown.
Session limit is not set.
Time since activation: never
Editing is enabled.
History is enabled, history size is 10.
DNS resolution in show commands is enabled
Full user help is disabled
Allowed transports are pad v120 telnet rlogin. Preferred is telnet.
No output characters are padded
No special data dispatching characters

DTR не горит.
Кабель cab-oct-232-mt
Модем Zycell 336s - исправен, на Cisco 1601 он работает.

Отклики:

• Re: Не взводится DTR ...... FiSh 19:51:27 9/30/99 (3)
  • Не взводится DTR ...... Yuri A. Kuznecov 07:21:15 10/01/99 (2)
    • Re: Не взводится DTR ...... FiSh 10:33:36 10/01/99 (1)
      • Re: Не взводится DTR ...... Yuri A. Kuznecov 11:53:08 10/01/99 (0)

Написать ответ