Re: Настройка shaping для CISCO1605
Отправлено: Andy Korolenko on August 10, 1999 at 19:02:14:
В ответ на: Re: Настройка shaping для CISCO1605 posted by Vladko on August 04, 1999 at 14:47:04:
Здравствуйте. > > Подскажите (или скажите где найти), как правильно (!) настроить shaping на этой CISCO1605.
> > Есть : Cisco IOS 11.3(3)T IP Plus Features pack, присутствуют комманды traffic-shape etc.
> > Но на www.cisco.com сказано, что для этой версии софта shaping ещё не доступен... > > Заодним, уточните, где конкретно можно посмотреть FAQ по состовлению access-lists...
> > shaping хочется получить для ip... > То есть не для интерфейса, а именно для конкретных групп ip адрессов.. Можно указать только для определенного access-list traffic-shape group
To enable traffic shaping based on a specific access list for outbound traffic on an interface, use the traffic-shape group interface configuration command. Use the no form of this command to disable traffic shaping on the interface for the access list. traffic-shape group access-list bit-rate [burst-size [excess-burst-size]]
no traffic-shape group access-list access-list Number of the access list that controls the packets that traffic shaping is applied to on the interface.
bit-rate Bit rate that traffic is shaped to in bits per second. This is the access bit rate that you contract with your service provider or the service level you intend to maintain.
burst-size (Optional) Sustained number of bits that can be transmitted per interval. On Frame Relay interfaces, this is the committed burst size contracted with your service provider. The default is the bit-rate divided by 8.
excess-burst-size (Optional) Maximum number of bits that can exceed the burst size in the first interval in a congestion event. On Frame Relay interfaces, this is the excess burst size contracted with your service provider. The default is equal to the burst-size.
Отклики:
Написать ответ
| 
