Re: VoIP

Тема:

Ваше сообщение:
> А микрофон в трубке не сдох, часом? :-) > Когда Вы говорите в трубку, тел. станция должна отправлять голос на правильный экстеншн, т.е. на циску, а на циске должен быть правильный dial-peer на NetMeeting. Тогда на NetMeeting'е должно быть слышно :-) > Если нет - значит у Вас что-то где-то неправильно. > С телефона на телефон - нормально все? Если да - то дело в dial-peer'e на NetMeeting, или в самом NetMeeting'е, больше, вроде бы, ничего не может быть. > > > > Добрый день! > > > > > > Есть проблема: > > > Cisco 1750 FXO 1 порт подключен к внутреннему exten. 110 на > > > PBX , звоним с > > > netmeeting v 3.01 sp1 build 3388 (NT 4 sp6a , IE5.01 , ess > > > 1938 , codec > > > g711alaw) на exten. 109 (набирая 110109) , снимаем трубу на телефоне и > > > говорим в микрофон на компутере - слышим голос в трубке - > > > говорим в трубку - > > > в колонках голоса нет!!! > > > > > > P.S. > > > 24 часа назад все работало , меняли конфиги и все что только > > > могло придти в > > > голову (кроме киски) , попробовали все что предложили на > > > Comptek Online > > > conference. > > > > > > PLEASE HELP > > > > > > > > > ! > > > version 12.0 > > > service timestamps debug uptime > > > service timestamps log uptime > > > service password-encryption > > > ! > > > hostname cisco_Techsell_ru > > > ! > > > ! > > > memory-size iomem 25 > > > ip subnet-zero > > > no ip routing > > > ip name-server x.x.x.x > > > ! > > > ! > > > ! > > > ! > > > voice-port 0/0 > > > cptone RU > > > description connected to PBX (+110) > > > ! > > > voice-port 0/1 > > > ! > > > dial-peer voice 30 voip > > > destination-pattern 205 > > > codec g711ulaw > > > session target ipv4:x.x.x.x > > > ! > > > dial-peer voice 11 voip > > > destination-pattern 209 > > > codec g711alaw > > > session target ipv4:x.x.x.x > > > ! > > > dial-peer voice 12 voip > > > destination-pattern 208 > > > codec g711ulaw > > > session target ipv4:x.x.x.x > > > ! > > > dial-peer voice 13 voip > > > destination-pattern 207 > > > codec g711ulaw > > > session target ipv4:x.x.x.x > > > ! > > > dial-peer voice 14 voip > > > destination-pattern 203 > > > codec g711ulaw > > > session target ipv4:x.x.x.x > > > ! > > > dial-peer voice 1 pots > > > destination-pattern 110 > > > port 0/0 > > > ! > > > process-max-time 200 > > > ! > > > interface FastEthernet0 > > > description connected to Techsell > > > ip address x.x.x.x 255.255.255.0 > > > ip helper-address x.x.x.x > > > no ip directed-broadcast > > > no ip route-cache > > > no ip mroute-cache > > > full-duplex > > > ! > > > ip default-gateway x.x.x.x > > > ip classless > > > ip http server > > > ! > > > ! > > > line con 0 > > > exec-timeout 0 0 > > > login > > > transport input none > > > line aux 0 > > > line vty 0 4 > > > no scheduler allocate > > > end > > > > > > > > > :::::::::::::::::::::::::::::::::::::::::: > > > Foreign Exchange Office 0/0 > > > Type of VoicePort is FXO > > > Operation State is DORMANT > > > Administrative State is UP > > > No Interface Down Failure > > > Description is connected to PBX (+110) > > > Noise Regeneration is enabled > > > Non Linear Processing is enabled > > > Music On Hold Threshold is Set to -38 dBm > > > In Gain is Set to 0 dB > > > Out Attenuation is Set to 0 dB > > > Echo Cancellation is enabled > > > Echo Cancel Coverage is set to 8 ms > > > Connection Mode is normal > > > Connection Number is not set > > > Initial Time Out is set to 10 s > > > Interdigit Time Out is set to 10 s > > > Call-Disconnect Time Out is set to 60 s > > > Region Tone is set for RU > > > > > > Analog Info Follows: > > > Currently processing unknown > > > Maintenance Mode Set to None (not in mtc mode) > > > Number of signaling protocol errors are 0 > > > Impedance is set to 600r Ohm > > > > > > Voice card specific Info Follows: > > > Signal Type is loopStart > > > Number Of Rings is set to 1 > > > Supervisory Disconnect active > > > Hook Status is On Hook > > > Ring Detect Status is inactive > > > Ring Ground Status is inactive > > > Tip Ground Status is inactive > > > Dial Type is dtmf > > > Digit Duration Timing is set to 100 ms > > > InterDigit Duration Timing is set to 100 ms > > > Pulse Rate Timing is set to 10 pulses/second > > > InterDigit Pulse Duration Timing is set to 500 ms > > > > > > :::::::::::::::::::::::::::::::::::::::::::::::::::::::::::::: > > > ::::::::::::: > > > > > > cisco_Techsell_ru#sh dial-peer voice 11 > > > VoiceOverIpPeer11 > > > information type = voice, > > > tag = 11, destination-pattern = `209', > > > answer-address = `', preference=0, > > > group = 11, Admin state is up, Operation state is up, > > > incoming called-number = `', connections/maximum = > > > 0/unlimited, > > > application associated: > > > type = voip, session-target = `ipv4:x.x.x.x', > > > technology prefix: > > > settlement: disabled > > > ip precedence = 0, UDP checksum = disabled, > > > session-protocol = cisco, req-qos = best-effort, > > > acc-qos = best-effort, > > > fax-rate = voice, payload size = 20 bytes > > > codec = g711alaw, payload size = 160 bytes, > > > Expect factor = 10, Icpif = 30,signaling-type = cas, > > > VAD = enabled, Poor QOV Trap = disabled, > > > Connect Time = 5493, Charged Units = 0, > > > Successful Calls = 7, Failed Calls = 0, > > > Accepted Calls = 7, Refused Calls = 0, > > > Last Disconnect Cause is "10 ", > > > Last Disconnect Text is "normal call clearing.", > > > Last Setup Time = 8560910. > > А где же у Вас dial-peer voice voip соответствующий? Я не увидел его в Вашей > > кофигурации... > > Должно быть что-нибудь типа > > dial-peer voice <tag> voip > > destination-pattern 109 > > codec g711alaw > > session target ipv4:<ip address> > > >Прописано , ничего не изменилось...... > >

Optional Link URL:
Link Title:
Optional Image URL: